spacer
Support - Platinum Support
tab end BCS Web Site divider MySupport divider Log Out navbar end
navbar end home symantec alerting service security center knowledge base navbar end
spacer
BCS Knowledge Base

spacer
spacer

Rate This Document
1x3 spacer
1x1 spacer

print this documentDocument ID:2009061513570448
Last Modified:11/17/2009

How to block a specific IP using the Symantec Endpoint Protection client firewall / Network Threat Protection (NTP)

Situation:You want to block network traffic associated with a specific IP address using the SEP client firewall, also known as NTP. How can this be accomplished?

Solution:Edit the firewall policy associated with the clients to add a corresponding rule as follows:
  • Open the SEPM, click the Policies tab, and edit the policy you wish to change
  • Add a blank rule
  • Modify the “Host” properties so that the “Source/Destination” IP is the address you wish to block (Local/Remote is less generic, and requires the local address of the client on which the rule should be applied)
  • Change the “Action” to Block
  • Save and deploy the policy as needed.



This will block all incoming and outgoing traffic associated with the specified IP address.

print this documentDocument ID:2009061513570448
Last Modified:11/17/2009


rate this document
Does this document answer your question?
Yes
No
Maybe, need to test
None of the above
Is this document well written and easy to use?
Submit specific suggestions to improve the quality of this document.


Product(s): Endpoint Protection 11
Operating Systems(s):
Date Created: 06/15/2009

  © 1995-2014 Symantec Corporation. All rights reserved. feedback | legal notices | privacy policy